Discussion On Equipment Problems Of Flat Screen Printing Machin


    Regarding Hot Air Stenter Machine, below, Flat Screen Printing Machine Factory will continue to introduce the products of this website, that is, elaboration of its related knowledge, or answers to related questions, so that everyone can build on the existing foundation. Come and continue to learn and understand, so as to increase your own professional knowledge in this area, to get new gains from it.
    1. What is the working process of Hot Air Stenter Machine?
    The working process of the stenter setting machine, specifically speaking, is:
    First, the unshaped cloth is fed into the setting machine through the edge stripper open width, and then the two ends of the cloth are hung on the needle plate, and the two ends of the needle plate are brought into the oven along with the mechanical operation. . After that, it is heated in an oven, and when it enters the end, it is cooled and destaticized. In this way, its swing can be dropped into the cloth car, thereby obtaining the desired effect.
    2. What is the burner used in Hot Air Stenter Machine? In addition, if the Hot Air Stenter Machine generates an oblique position, how to deal with it?
    In Hot Air Stenter Machine, the burners used generally depend on the technical requirements and the specific configuration. Therefore, there are many brands for everyone to choose from. As for the oblique position of the Hot Air Stenter Machine, its processing is: if the sizing machine has two motors, then it can be solved by adjusting the motor speed, and if it is one motor, then it is Weft straighteners are added to the cloth feed frame and the front of the car.
    3. After the jersey passes through the Hot Air Stenter Machine, if there are vertical stripes on the surface, what is the problem?
    If this problem occurs on the Hot Air Stenter Machine, then the specific reason is: the shrinkage rate of the fabric structure is too large. Moreover, sometimes, this is also inevitable. Through Hot Air Stenter Machine, only fine-tuning can be made, but this problem cannot be completely solved. Therefore, everyone should pay attention to it and not take it lightly.
    Hot Air Stenter Machine, for this kind of machine equipment, I must be familiar with it, because there is an explanation about this before. Therefore, in order for everyone to have content to continue learning, and to enhance understanding and understanding, the following editor will explain this aspect well to achieve the above purpose.
    Hot Air Stenter Machine, its working principle, its main is:
    The unshaped cloth is fed into the machine through the stripper open width, so that both ends of the cloth width can be hung on the needle board. After that, through the movement of the needle plate, the cloth width is sent into the oven, and passed through several constant temperature ovens at different temperatures, and then the tail end is cooled and static electricity is removed. After that, the cloth width falls into the cloth car, thus completing the whole setting process.
    Question: Is the width of knitted fabric related to the setting machine?
    Answer: The width of knitted fabric has nothing to do with the setting machine, because the setting machine can only play a fine-tuning role.